Studio Electronics Toolbar
The TOOLBAR is the perfect euro (read social) lubricant to warm, warble, delay and flange-up your Tonestar with it’s down ‘n’ dirty digital delay; it’s attenuation, invert, route, hi cut circuits are likely worthy of your interest and experimentation as well.
Greg St. Regis NAMM 2017 Specs Left to Right:
Attenuator with normal and inverted outs
1 in 2 out router with short lag/hi cut filter on the 2nd out
Analog LFO tri/sqr out with range switch and LED
Stereo digital delay with level, amount, wet pan, dry pan, time, feedback, and LFO to time CV in control to delay amount
True bypass, 3.5mm mono and TRS stereo out.
10 Potentiometers
ATTN: AMNT; HI CUT: AMNT; LFO: RATE; DELAY: LFO (^), TIME, W-PAN, D-PAN, AMNT, REGEN; IN.OUT: LEVEL
3 Switches
ROUTE: a/null/b; LFO: RANGE; DELAY: BYPASS
12 Jacks
ATTEN: IN, INV, OUT; ROUTE: IN, OUT; HI CUT: OUT; LFO: TRIANGLE, SQUARE; DELAY: CV IN; IN.OUT: STEREO, IN, MONO
All Controls and Patch Points
ATTEN:Â
IN – Audio or CV input.
AMNT – Amount of attenuation.
INV – Inverted output.
OUT – Output.
AMNT – Amount of attenuation.
INV – Inverted output.
OUT – Output.
ROUTE:Â
IN – Input.
OUT – Output A.
OUT – Output B.
OUT – Output A.
OUT – Output B.
HI CUT:Â
AMNT – Hi frequency cut amount.
LFO:Â
RATE – Speed control for low frequency oscillator.
RANGE – Slow and audio rate.
TRIANGLE – Triangle waveform.
SQUARE – Square.
RANGE – Slow and audio rate.
TRIANGLE – Triangle waveform.
SQUARE – Square.
DELAY:Â
LFO (^) – Low frequency oscillator.
TIME – Delay speed.
W-PAN – Wet pan.
D-PAN – Dry pan.
CV IN – Delay amount control voltage input.
AMNT – Effect Amount.
REGEN – Echo repeat or regeneration.
BYPASS – (Relay) bypass.
TIME – Delay speed.
W-PAN – Wet pan.
D-PAN – Dry pan.
CV IN – Delay amount control voltage input.
AMNT – Effect Amount.
REGEN – Echo repeat or regeneration.
BYPASS – (Relay) bypass.
IN.OUT:
LEVEL – Master output level.
IN – Delay input.
STEREO – Stereo output.
MONO – Mono output.
IN – Delay input.
STEREO – Stereo output.
MONO – Mono output.
VITALS
PCB Mounting Scheme – Through-hole.
Size – 32hp.
Depth – 35mm including connectors.
Power Usage – 30mA, 25mA (+12 / -12)
Size – 32hp.
Depth – 35mm including connectors.
Power Usage – 30mA, 25mA (+12 / -12)
